I solve problem to connect to addreess 09 so, that I turned off the car, then I locked the car and unlocked again and then I could connect to address 09: Cent. vehicles from 2015 may use controllers that the HEX+CAN & Micro-CAN can no longer read, for these you will need the HEX-V2 or HEX-NET interfaces.
#VCDS NO RESPONSE FROM CONTROLLER SERIAL#
Posts: 1,024 Likes: 0 Received 0 Likes on 0 Posts The download page of Ross-Tech say 'If youre using an older SERIAL Interface based on Opto-Couplers. Part No SW: 1Z0 919 475 C HW: 1Z0 919 475 A VAG-COM makes 4 attempts and then reports 'NO RESPONSE FROM CONTROLLER.' Reply Like. And finally if I run the 'Control Module Finder' the 01-Engine module is found but I still cannot access it. and finally 'No Response From Controller' If I try and open the 'OBD-II Functions' I get. Its already activated to support all manufacturer codes, tuning, coding functions.
#VCDS NO RESPONSE FROM CONTROLLER FULL VERSION#
Part No SW: 3T0 907 044 AS HW: 3T0 907 044 ASĪddress 10: Park/Steer Assist (J446) Labels: 3C8-919-475.clb If I try and connect to the 01-Engine module via the 'Select Control Module' I get this sequence of screens. 1 x license of VCDS V20.4.0 full version software including drivers, software download link and installation guide. So I went to the VAG COM setup chose COM3 and confirm it identifies the cable.
In VagCom setup COM3 reported as seeing the cable succesfully but like you got no response when connected to the car. Saturday,25,September,2010,15:26:35:14583 I had this problem with an Ebay cable and VCDS lite (and VAGCom 409) - here's how I fixed it. I select auto scan function and I got this result: Today I tried to connect to the car computer.